Información del Producto:
Este Coude Macho Latón es un accesorio de tubería bajo IFAN. Un extremo es un accesorio de tubería, que se puede conectar con una tubería PEX; el otro extremo es un racor roscado hembra, que se puede conectar directamente con un racor roscado del mismo tamaño.
Coude Male Brass es un accesorio resistente, y cuando buscábamos un accesorio de tubería estable, el Coude Male Brass era una excelente opción: tiene una gran resistencia, es lo suficientemente fuerte y confiable como para adaptarse bien a los sistemas de tuberías PEX.
Proceso de instalación de latón macho Coude: el más fácil de instalar es el accesorio de tubería de latón PEX, solo necesita una pequeña herramienta y puede completarlo fácilmente.
Tamaño del producto:
Tamaño | PC/Bolsa | Peso | CBM |
L161/2"F | 200 | 95 | 0.011 |
L181/2"F | 150 | 107 | 0.011 |
L201/2"F | 150 | 133 | 0.011 |
L203/4"F | 150 | 142 | 0.011 |
L263/4"F | 100 | 168 | 0.011 |
L323/4"F | 50 | 332 | 0.011 |
L321"F | 50 | 340 | 0.011 |
Características del producto:
In the process of using the ferrule joint, its sealing is a very important performance. We need to do the sealing installation during installation. So how can the sealing installation of the ferrule joint be carried out? Let's take a look at the relevant instructions:
In order to ensure the installation and sealing of the ferrule joint, first cut off the seamless steel pipe of appropriate length with a saw blade, remove the port burr, and insert the nut and fastener on the seamless steel pipe; pay attention to the direction of the nut and bite, do not install it in reverse, Apply lubricating oil to the screws and ferrules of the pre-assembled joint body, insert the steel pipe into the joint body, and tighten the nut by hand; tighten the nut until the fermenter steel pipe is caught by the fermentor. This turning point can be felt by the increase in tightening torque. to; when the pressure point is reached, tighten the nut 1/2 turn, remove the pre-assembled fitting body, and check the insertion of the cutting edge of the ferrule, the visible protruding band must fill the space at the front of the ferrule, it can turn slightly, but Can not move axially; in the next installation, the thread of the joint body should be lubricated with lubricating oil, and the compression nut should be screwed together until you feel the tightening force increase, and then tighten the ferrule joint 1/2 turn, complete Install.
